![]() It is unclear from your post, but if you have a default output mapped to the HD I/O it is entirely bypassing your Omni and the monitoring controller. Find your output bus and choose your new monitor path under the "mapping to output" column.įrom there, you should be good to go. From here, you need to assign your default output bus in the bus tab to that new output. In the outputs tab you should see your new monitoring path with a greyed out "monitoring" written in the output assignment. I allso make sure the "record/input monitor enable:" dropdown menu is set to Mutes Mixer Inputs so that I don't hear the same audio twice if I want to record those inputs through Pro Tools.Ĥ. Doing this means you will hear your computer sounds through your omni even when Pro Tools is closed. Hit the "Mixer" tab and make sure "Mon" and "HP" are selected under the channel labelled "Analogue 1-2". And choose what inputs you want to plug in your OS system sound (ie. Hit the "main" tab, and make sure your outputs are corrected assigned to Monitor 1-2, Monitor 3-4, Monitor 5-6, Monitor 7-8. ![]() If you hit the 'Alt' button on your omni, it will fold down your 5.1 mix to stereo.Ģ. Then select "fold down between CR Paths" under the Control Room Fold Down heading. Select stereo in the format column, and drag the L and R boxes to match those of your main speaker outputs. ![]() Note that the 'Alt' column can be used for a 5.1 stereo down mix. Mine is set to L, R, C, etc rather than the default L, C, R. Choose your output format from the dropdown menu in the 'main' column, then configure your speaker order by dragging the L, R, C, etc boxes around. Go to setup -> hardware and click the 'monitor' tab. I take it I can run my computer output into a pair of the inputs and mix into the monitor outs?ġ. I also see there is a mixer tab in the Omni hardware setup. I can hear playback through phones connected to the Omni but nothing out of the speakers. The analog outs on the Omni are connected to the speakers (LR anyway). Only the input section has been expanded. There is a default 7.1 path set to output through a second set of 1-8 on the 192 but there are only 8 analog outputs on that. I want to use the Monitor Controller section in the Omni but am unsure how to route the analog out of the Omni or how to configure the monitor output. I have a support ticket open but Avid are slow to respond. I just added the Omni and everything seems to be good in the Hardware setup, all buttons are green on the interfaces but I have some IO/Monitor setup questions as the user guides are less than clear. I am on an HDN which has been running an HD IO 16x16 and an input expanded 192 and monitoring through a console. Just starting a new contract gig and need to set up for 7.1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |